Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
What reamers does everyone recommend for line boring bulkheads and axle holes?
Do you use a smaller size first and work up ?
Any recommendations for brand and size?
Moved the tread.
I have not seen a difference in brands.  I know a lot of guys do ream, but I do not.
I normally use  blue bushing for super stock cars and bronze for cars with hot arms.
Remember to add your races to the RACE Calendar
The RACE Calendar

Hi Mike. Like SK said... the Scale Engineering bushings are the way to go. I do however, ream them.
PM me if you want source name for them.
I had looked at those bushings previously, and have recently purchased a few of Mark tools. Maybe I should have ordered the bushes too ? always next time.
What size reamer do you use Hobro? 1.5mm?

Forum Jump:

Users browsing this thread: 1 Guest(s)